How Does a Wifi Repeater Extend Your Existing Wifi Network? Step 7 – Start Using Your Wifi Repeater.Step 6 – Finalize the Settings Through The Set-Up Wizard.Step 5 – Complete the Set Up Through Your Default Browser.Step 4 – Conduct the Required Configurations.Step-By-Step Guide to Set Up a Wifi Repeater.Why do you Need to Attach a Wifi Repeater to Your Wifi Router?.Wifi Repeater or Booster? – Which Is Better To Improve Your Wi-Fi Signal?.How Does a Wifi Repeater Extend Your Existing Wifi Network?.While the device is power on press and hold the reset button until all LEDs momentarily change, then release the button and wait for the device to reboot. Please reset the Device and go through the configuration again.Please log into the Device's web-based interface to check the password and try again. You may have entered the incorrect Wi-Fi password of your host Wi-Fi during the configuration.What to do if the LEDs do not change to solid after completing setup Verify that is correctly entered in the web browser and press Enter.Make sure your computer is set to obtain an IP address automatically.Make sure the computer is connected to the extended network SSID or connect to the device using an Ethernet cable.It may cause the firmware upgrade to fail and the device will become unusable. Note: Do not interrupt the device, close the web browser or power off the device during a firmware upgrade. Click Apply and wait a few minutes for the firmware upgrade to be complete.Click Browse to locate the downloaded new firmware file.Enter the older password then enter the new password and click Applyįirmware upgrade can fix bugs related to the device, however it is not recommended to upgrade the firmware if the device is working normally and stable.Go to and login with the default password admin.The default password for the device is admin, it strongly recommended the password is changed from the default. Wireless network settings can be configured from here.Management via Web Browser Wireless basic configuration If the WPS connection fails, please connect the device using a web browser. Note: Some ISP gateways disable the WPS function by default. The corresponding WLAN LEDs should turn on and stay solid, indicating successful connection.The device will reboot, please wait a few minutes.Within 2 minutes, press the WPS button on your host router.Press and hold the WPS button for 6 seconds on the device.Setup - Wi-Fi Repeater Mode Using a WPS (Wi-Fi Protected Setup) If the signal is weak, relocate it closer to the router to achieve a good (or better) signal quality. The location you choose must be within the range of your existing host Wi-Fi. Plug the device into an electrical out about halfway between the host router and the Wi-Fi dead zone.Verify your wireless settings and click The Wi-Fi Signal LEDs should turn on and stay solid, indicating successful connection.Either keep the same SSID as your host Wi-Fi or create a new name for the extended network. Select the Wi-Fi SSID for your router (Host Wi-Fi) and enter the password.Enter admin (all lowercase) in the password field at login.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |